Installation
25
AZURA V 2.1S User Manual, V6860, Version 2.2
You will find patch cables for each device and the router in the accessories kit.
To connect the router to a WAN, an additional patch cable is required, which is
not supplied within the scope of delivery.
Prerequisite
The computer has been switched off.
There is a patch cable for each device and the computer.
Process
1. Use the patch cable to connect the router and the computer. Repeat this
step to connect all devices.
2. Use the power supply to connect the router to the mains power system.
Configuring the Router
The router is preset at the factory. You will find a label at the bottom side of the
router, on which IP address, user name, and password are printed. These infor-
mation help to open the router configuration.
Process
1. To open the router configuration, start your Internet browser and enter the
IP address (not for all routers).
2. Enter user name and password.
3. Configure the router as DHCP server.
4. In the router configuration, check the IP address range and make changes if
necessary.
Result
Once the router has assigned IP addresses to all devices, the chromatography
software can be used to remotely control the system.
Integrating the LAN into a Company Network
A network administrator can integrate the LAN into your company network. In
this case you use the WAN port of the router.
1
2
3
4
5
