Knauer Azura Assistant ASM 2.1L, User Manual, Page: 14 / 35

ASM 2.1L user manual V6815
Unpacking and setup 14
Prerequisite Check packaging for damage caused during transportation. If necessary,
put forward any claim for damages to the carrier.
Tools Utility knife
Bruising danger
Damage to the device by carrying or lifting it on protruding housing parts.
The device may fall and thus cause injuries.

Lift the device only centrally on the side of the housing.
Process
1. Set up the package in such a way that you can read the label. Using the
utility knife, cut the adhesive tape and open the packaging.
2. Remove the foam insert. Take out the accessory kit and the manual.
3. Open the accessory kit and check the scope of delivery. In case any
parts are missing, contact the Technical Support.
4. Clasp the device from below, lift it out of the packaging and place it on
its feet. Do not hold onto the front cover.
5. Check the device for signs of damage that occurred during transport.
In case you notice any damage, contact the Technical Support.
6. Place the device in its site of operation and remove protective foil.
Next steps Store packaging and keep the included packing list for repeat orders.
Connectors on the rear side
Device defect
Changes of the environmental temperature cause condensation inside
the device.

Allow device to acclimate for 3 h, before connecting to power supply
and taking into operation.
External devices like computers, fraction collectors, etc. can be connected
in 2 different ways to the detector:

Control with pin header

Connected to LAN within a network
Controlling with the pin header
Electronic defect
Connecting cables to the multi-pin connector of a switched on device
causes a short circuit.

Turn off the device before connecting cables.

Pull the power plug.
Connector Assignments The single ports exchange start, control and error signals with other
devices. Events can only be controlled by software.
Legend
1
Label with serial
number
2
LAN port
3
Interface for the
Technical Support
4
Pin header
5
Fan
6
Integrator output
7
Connection and
power switch
Fig. 5 ASM 2.1L rear view
2 3 4 5 6 7 1