2700 Oak Industrial Drive NE, Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
Top & Bottom Mounting
Wire Full Round Lazy Susan
Installation Instructions
RN-263EFS-B/0911
© 2011 Knape & Vogt. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly
and installation.
Step 1 To locate the unit inside your
cabinet, place a shelf on the
post and position it inside the
cabinet so the door can
close without interference.
Mark all screw hole locations
on the cabinet floor.
Remove the post and shelf
from the cabinet. Drill pilot
holes for fastening screws,
and attach the post to the
cabinet floor using the
screws provided.
Step 2 Assemble the shaft collars by
placing T-nuts through holes
and inserting setscrew into
T-nut. Turn screw 2 or 3 times
to engage. It will be
tightened later. Place one of
the shaft collars (slotted side
up) at the desired height for
the lower shelf and tighten
setscrews finger-tight to hold
in place. Tighten the
setscrew on the collar and
close the door to check for
clearance.
Step 3 Place the remaining
shaft collar(s)
(slotted side up) on
the post and repeat
the installation
instructions above.
Insert the top mount
support in the top of
the post. Lift the top
mount support up
towards the top of
the cabinet and
secure it in place
using screws and
washers provided.
Installation is now
complete.
Parts Included
A. (2) Shelves
B. Post
C. (2) Shaft collars
D. (4) setscrews
E. (4) T-nuts
F. Top Mount Support
G. Mounting screws
Tools Required
• Phillips head screwdriver
• Drill with 1/16” (1.5mm) bit
for drilling pilot holes
• Pencil
Product Assemblies
FR24STM
FR28STM
A
B
E
G
step 1
step 2
step 3
F
C
D
F
G
