Base Rollout
BASE CABINET ORGANIZER
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
800.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
RN-213EFS 02/03
© 2003 Knape & Vogt Manufacturing Company. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. Carriage assembly
B. Slide bracket
C. Mounting screws
Note: Baskets sold separately
Tools Required
• Phillips screwdriver
• Drill with 1/16” bit for pilot holes
(optional)
Product Assemblies
B1700
Step 1
Unit will arrive with carriage assembly
engaged in slide bracket. Place baskets
(baskets sold separately) on the desired
hooks on the carriage assembly. Place
carriage assembly on cabinet floor,
against the back edge of the cabinet
face frame. If installing in a frameless
cabinet, measure 1/2” to 3/4” back
from the front of cabinet opening, and
align carriage assembly parallel to
cabinet opening. Close door to make
sure the carriage assembly does not
interfere with the door operation.
Step 2
Once basket position and clearances
are determined, remove baskets, being
careful not to alter the position of the
carriage assembly. Use the mounting
screws provided to fasten the assembly
to the floor of the cabinet through the
four slotted holes in the slide bracket.
Optional step: mark placement of
mounting holes with pencil, carefully
remove carriage assembly and drill pilot
holes for fastening screws. Place
carriage assembly back into position
and fasten with the provided screws.
Hang baskets. Installation is complete.
A.
B.
C.
step 1
step 2
