KMX Karts Kompact Sports Trike, Assembly Instructions Manual, Page: 4 / 14

Pedals
.
Attach the pedals. The Left side pedal has a left thread and Right side pedal has a right thread. The pedals
are marked with an “L” and “R” accordingly.
Chain
Starting from the front top chain tube feed half the chain length through the front chain tube, under the Pulley,
through the rear chain tube and around the Derailleur. Feed the remaining chain around the chain tensioner,
front chain ring and through the bottom chain tube. (Use Photos 9, 10 and 11 as a guide).
Connect the ends of the chain using the Quick Link Connector provided (Photo 12).
Seat
Slide the Seat Stay Tubes over the Seat Stay Adjusters that are attached to the Dropouts (Photo 13).
Select the second hole from the Dropout end and insert the bolt through the Seat Stay and secure it with the
knob provided. (Photo 14).
Attach the bottom of the Seat to the trike frame with the clamps provided. (Drawing C).
TRIKE SET UP
Place the trike on the floor.
Slide the boom into the shortest position.
Position the seat along the frame to give a comfortable angle when seated.
Sit in the seat and adjust the boom length so that your right leg is straight with no bend at the knee when the
right pedal is at its furthest point and your heel is on the pedal (Photo 15). This will ensure that when you are
cycling and you have the ball of your foot on the pedal, you will have a slight bend at the knee (Photo 16). If
you cannot reach the pedal then move the seat forward by extending the seat stays and sliding the seat
clamp forward on the frame. When you are happy with your final position, tighten the boom, seat stay and
seat clamp screws.
HANDLE BAR SET UP
Sit in the seat and set the handlebars to a comfortable reach and angle, making sure your hands
are clear of the tyres. Tighten the handlebar clamps (Photo 17)
Note: The maximum extension of the handlebars is 20mm
.
FRONT WHEEL ALIGNMENT
Place the trike on level ground and measure between the inside of the front tyres in the positions
shown (A and B). Loosen the lock nuts at either end of the steering rod (1 x Left & 1 x Right
hand thread). Turn the rod until the measurement between the front and rear of the tyres is
equal. Now retighten the lock nuts. (Photo 18).
FITTING THE FLAG
If required fit the Flag to the rear wheel axle by first loosening the quick release clamp or axle nut. Insert the
flag bracket and tighten the clamp or axle nut (Photo 19).
Fitting the Front and Rear Reflectors
.
For suggested Reflector positions, refer to Photos 20 and 21.