KMX Karts Kompact Sports Trike, Assembly Instructions Manual, Page: 3 / 14

3.0 Assembly Instructions
Carefully lift all the items from the box and remove the protective packaging.
Rear Mudguard
Attach the rear of the mudguard to the wire stay with the M5 Bolt, nut and washer provided. (Photo 1).
Attach the front of the mudguard to the frame with the M6 Bolt, nut and washers provided. (Photo 1)
Rear Wheel
Insert the Rear Wheel and secure using the Nuts and Washers or Quick Release provided. (Photo 2).
Front Wheel Assembly
Take the Right Front Wheel Assembly (the one with the gear changer) and attach it to the frame using the
M8 Nut, bolt and washers provided. Insert the Plastic Cap (Drawing A).
Repeat for the Left Wheel Assembly.
Fold the front chain tube forward, place the steering rod above the chain tubes and attach the rod ends with
the M8 Nuts, bolts and washers provided. (Drawing B).
Front Brake
Attach the brake cable from the Left Wheel to the Double Brake Lever (Photo 3).
Rear Brake
Cut the cable ties holding the rear brake cable to the Left handlebar. Turn the trike upside down and attach
the brake cable to the “V” Brake (Photo 4) noting the cable routing in (Photo 5).
NB. If you are not familiar with how to set up your brakes then we would recommend that you visit your local
Bike Shop.
Rear Derailleur
Attach the Rear Derailleur to the right side Dropout (Photo 6).
Cut the Cable ties securing the Gear Cable to the Right handlebar. Ensure that the Twist grip changer is in
Number 7 and attach the Cable to the Derailleur (Photo 6) noting the cable routing in (Photo 5 and 6).
NB. If you are not familiar with Rear Derailleur set up then we would recommend that you visit your local
Bike Shop.
Cable Routing
Secure the brake cables and gear cable to the steering rod with the cable ties provided (Photo 5).
Front Boom
Insert the Boom fully into the front of the frame (Photo 7).
Remove the nut and washer from the front Quick Release Clamp. Position the slot in the Chain Tensioner
arm over the Quick Release Clamp Bolt and replace the Nut and Washer. (Photo 8).
Adjust the Quick Release Clamps so that the Boom is free to move when they are released but is held firm
when the Clamps are tightened.