www.kmwcomm.com
KMW Antenna Installation Guide
Mounting kits for ET-X-TU-42-15-37-18-iR-RA
Step 4
RET Replacement
1. Separate RET cable.
2. Unscrew two knob screws
3. Disconnect an inner cable
4. Replace RET
Note
Need to use a flat-head screwdriver with 10mm width
and 1mm thickness to assemble and separate a RET box.
If you use under 10mm width tool, Knob Screw could be
damaged.
Knob Screw Recommended torque : 4.3lbf.in [5kgf.cm]
Knob Screw assembly tool
*. Refer to the color coding for RF cables/connectors
*. RF Connector recommended torque : 264lbf.in [304kgf.cm]
*.
AISG Connector
recommended torque: 4.3~8.6lbf.in [5~10kgf.cm]
(The connector should be tightened by hand only!)
*. Waterproof on the connectors
Please be careful of damage to connector, down cap and RET by
heat if waterproofing need a heat after connect cable.
*. Warning!
Do not turn on the power for a controller until all the cables
have been properly installed.
KMW Communications Inc.
Base Station Antennas
For Mobile Communications
