Version 2018-11
49
Technical Data are subject to change without notice!
Solder the end of the wire on the AC IN of the
IND-PWR module and isolate all solder points with
shrink tubing.
Fixed with 3 layers mounting tape
Note: “The inductive load of the MTP- IND-PWR and
the capacitor in the Power Head must be in resonance
to get the optimal transmission. The inductive load of
the shaft depends of diameters, material and number of
windings!
Control the output voltage and move the power-head in
the max distance to the coil.
The output voltage must be 6.5 V!
The pins “Coil” are the AC power input from the coil. On
the pins “+6.5” and “GND“ you get a stabilized output
voltage of 6.5V DC.
The max. load current on the DC output is 2400mA.
The IND-PWR converter will use instead battery pack!
Never use any battery together with the MTP-IndPwr!
You should mount the power head at a fixed location
that it’s as free as possible from vibration influences.
The center of the coil should be in the same horizontal
position as the center of the power head. The distance
is optimal in the range between 5 and 10mm. (depends
of shaft and current consumption)
AC IN
6.5 DC OUT
max. 2400mA