Version 2018-11
30
Technical Data are subject to change without notice!
Inductive transmission (2500kbit) with MTP-IND-TX-RX with 45MHz carrier!
With 45MHz
carrier is only
1x
winding
necessary!
Attach for electromagnetic insulation “Ferrite Tape”
2 x one
layer around the shaft.
Make transmitting coil with 1x winding and twisted the
end of wire. Use CUL 0.63-1.00mm wire
(CUL = Enamelled copper wire)
Fixed it with 3 layers mounting tape
Extend the CUL wire flexible 0.14-0.25mm wire
(to decouple the inflexible 1mm wire!,
at 0.63 not necessary)
Twisted also the flexible wire and solder it on the MTP-
IND-Tx (isolate all solder points with shrink tubing)
Strip the isolation from the end
of the wire with a skinning tool or
head up you soldering iron over
450°C to burn off the insulation
from the wire!