KMS UEGO Display manual
Version 1.01
7
6. What do you see on the display?
When you have connected the display at the
right way then you will see this starting
screen.
After this screen the controller will heat the
lambda sensor (750 °C) before it will begin to
work.
This may take 10-15 sec.
(note : if you don’t have a lambda sensor attached you can still see and modify the
options in the menu by pressing the scrolling down button)
When the sensor is heated up you can see the air/fuel ratio that your lambda
sensor has measured. If your car hasn’t run for a while then the display will show
you a high number because of the high percentage of oxygen in the exhaust.
This display on the right shows when everything is
ready to use. (under normal condition when the
engine is shut of for quite a while. Environment
values like temperature depends on the place
where the car stands)
The displayed settings are the default settings.
(note : if you want to change these settings you can adjust them in the menu)
