KMC Controls BAC-4000 series, Installation, Operation, And Application Manual

Page: 39 / 128

Se c t i o n 4: C o m m i s s i o n i n g f u n c t i o n s
This topics in this section are advanced topics for control technicians and
engineers. These topic cover procedures for the initial AppStat setup.
The AppStat commissioning functions are values and settings that are entered
during the installation and commissioning of a controller and the equipment
it is controlling. Typically these functions do not change after the installation
and commissioning process.
To set up the commissioning functions, you will need the following
information.
Information about the equipment
The sequence of operation for the equipment
The building automation system plans for controllers that are part of a
network.
Users may change the occupied heating and cooling setpoints without
accessing the commissioning functions. This procedure is covered in the topic
User functions on page 31
.
Note:
The instructions for the AppStat commissioning functions cover all of the
functions that can be set in the controller. Not all functions are available on
every model of controller. Consult the installation and operation manual
supplied with the controller to verify the application programming in the
AppStat.
Installation, Operation, and Application Guide for AppStat
Revision G 39