7. Use hex key (not included) to fully tighten the two bolts on the jaw clamps
(See Figure 9).
8. Push the angle grinder downwards to locate the angle grinder disc in the
cutting slot on the base. Adjust bolt (B) and bolt (C) to make the disc
located in the middle of the slot (See Figure 10).
9. Use hex key (not included) to fully tighten the two bolts that connect the
stand with the base (See Figure 11).
10. Adjust bolt (B) and bolt (C) again to make sure that the disc can still locate in
the middle of the cutting slot on the base.
11. Loosen the nut on the handle and assemble the handle on the stand
(See Figure 12).
12. Unscrew the locking nut on the
lever (See Figure 13).
13. Insert the lever into the hole on the
safety guard and screw the locking
nut on and fully tighten it. Fully tighten the other nut on the lever (See Figure 14).
14. Unscrew the bolt (D) on the stand (See Figure 15).
15. Insert the lever into the hole on the stand (See Figure 16).
bolt B
bolt C
5
6
9
13
15
16
14
12
10
11
bolt D