3. Assemble the stand on the base by
using the two bolts (A).
Finger tighten these two bolts
(See Figure 5).
4. Insert the M10x68mm bolt (with nut)(B) and M10x50mm bolt (with nut)(C) into
the two holes on the stand. Finger tighten the two bolts (See Figure 5).
4. Screw the handle on the grinder stand. (Figure 8)
5. Lever assembly: Use hex key wrench to tighten the lever on the grinder stand.
(Figure 9)
5. The 2 x M10x30mm Bolt with nut, 2 x M8x25mm Bolt with nut, 2 x M6x25mm
Bolt with nut and 4x plastic spacer included in the pack are for assembling different
sizes of angle grinders on the stand. Check the size of the holes on your angle
grinder head for assembling the side handle. Pick the bolts that can fit these holes.
If you pick the M10x30mm bolts, then you don’t need to use the plastic spacer
with them. If you pick the other bolts, then you will need to use the plastic spacer
with them (See Figure 6 & 7).
6. Put the head of your angle
grinder between the two jaw
clamps. You may need to adjust
the distance between the two
jaw clamps according to the
size of the angle grinder head
(See Figure 8). Use the suitable
bolts you just picked to fix the
angle grinder head on the jaw
clamps. Use adjustable wrench
(not included) to fully tighten
the bolts.
2
5
3
6
7
8
10
11
6
7
4
bolt(A)
bolt B
bolt C
3
4
1. Unscrew the two bolts on the jaw clamps and use these two bolts to fix the
jaw clamps on the stand. Finger tighten the two bolts. Do not fully tighten them
as you may need to adjust the distance between these two jaw clamps
according to your angle grinder size (See Figure 2 and 3).
2. Unscrew the two bolts (A) that are already assembled on the base (See
Figure 4).
Assembly: