
5 OF 7
1. Make sure that the air valve (or trigger) is in the “off” position before connecting to the air
supply.
2. An air pressure of 90 PSI is required.
3. Drain the air tank daily. Water in the airline can damage the tool.
4. Clean the air inlet filter weekly.
5. Line pressure should be increased to compensate for longer air hoses (over 26 feet or 8
meters). The hose diameter should be 3/8in. I.D.
6. Keep the hose away from heat, oil and sharp edges. Check the hose for wear and make
certain that all connections are secure.
MAINTENANCE
WARNING:
Make sure the
Angle Grinder
is disconnected from its power source before attempting
any maintenance, cleaning, or inspection.
•
Maintain your
Angle Grinder
. It is recommended that the general condition of any tool be examined
before it is used. Keep your
Angle Grinder
in good repair by adopting a program of conscientious
repair and maintenance in accordance with the recommended procedures found in this manual. If
any abnormal vibrations or noise occurs, turn the
Angle Grinder
off immediately and have the
problem corrected before further use. Have necessary repairs made by qualified service personnel.
•
Keep all cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control. Keep handles dry, clean, and free from oil and
grease.
•
Cleaning. Use only soap and a damp cloth to clean your
Angle Grinder
. Many household cleaners
are harmful to plastics and other insulation. Never let liquid get inside the
Angle Grinder
.