+
-
-
+
-
+
cross-section
side view
bottom view
cross-section
1.
Install the cover, LED and both the conductive end caps. The conductive
plates inside the end caps must be soldered each to the separate pole on the
LED stip.
2.
Insert the rods into the holes in the head of the conductive end caps in
tighten them with an allen wrench.
3.
Install the W-KG-Z ceiling fasteners. The fastener installation manual can be
downloaded at
www.klusdesign.com
. Connect the cables, each for the single
power pole to the fasteners. The cables should go through a pre-drilled hole just
under the masking cover of the fastener.
4.
Mount the fixture with rods into the ceiling fasteners. Mind that the
power poles connected to the rods should match the ones connected to the
end caps.
OLEK - suspended fixture mounting instructions
2. Rod - conductive driven power supply
*If fully built fixtures are ordered and received from KLUS please skip to #3
3
www.KlusDesign.com
