5
MOD-TEK-100 - mounting instructions
b) Preparation of the OMODO-100 lighting fixture
www.KlusDesign.com
IIb
IIIb
5.
8.
9.
8.
9.
6.
2.1
Ib
1.2
2.2.
a.
holes for locking bolts ø 2,5 mm / 0.1”
item
(1.2)
b.
hole for a gland ø 6,5 mm / 0.26”
bottom view
7.
2.1
1.2
1.2
1.2
1.2
7.
2.1
top view
a.
Drill holes for locking bolts in the
profiled orientation line in the profile
(2.1)
.
The number of holes must be equal
to the number of bolts used. Each
hole should be in the middle of the
corresponding item
(1.2)
. There must
be a minimum of two bolts per
1 meter of a profile.
b.
Drill a hole in the profile
(2.1)
for the cable gland.
NOTE!
The profile
(2.1)
must be
shortened by 6 mm / 0.24” at each end
where the end caps will be mounted.
Adhere the LED tapes
(5)
, mount
the gland
(6)
and route the power
cable through it.
Attach end caps to the item 2.1
(8)
with the bolts
(9)
.
Locking bolts
(2.2)
can be
tightened preliminarily in the
pre-drilled holes before mounting
the profile at its destination
(after mounting the LED tapes).
Run the power cable to the
power supply through one of the
channels in the profile
(2.1)
,
so that it does not protrude
above the surface.
Then connect it with the power
supply
(7)
.
