IMPORTANT:
At least two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the display.
Maximum flat or curved panel weight:
50kg/110lb
The wall structure must be capable of supporting at least five times the weight of the panel.
Otherwise, the wall structure must be reinforced.
3. WARNING!
• Prior to installing this product, you must read all instructions thoroughly. Keep these installa-
tion instructions in an easily accessible location for future reference.
• Safety measures must be practiced at all times during the assembly of this product. Use
proper safety equipment and tools for the assembly procedure to prevent personal injury.
• KlipXtreme does not warrant against damage caused by the use of any Klip Xtreme mounts
for purposes other than those for which it was designed or damage caused by unauthorized
attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any manner
relating to any such use, attachments or modifications.
Max load 50kg/110lb
50
kg
4. Wall plate installation
1. Open the package and review its contents.
2. For gypsum or wooden walls, first locate studs in the wall. You may use a stud finder to
determine the center of each stud.
3. Using the wall plate as a template, mark the four mounting positions as shown in the drawing
below, with the bubble level determine if they are level in relation to the ground. Make sure
the mounting holes are aligned vertically and centered on the stud.
4. Before drilling the mounting holes on the wall, position the wall plate in place and use the
bubble level to check if it is completely horizontal, as it is shown in the drawing. In case it
weren´t, make the necessary arrangements and proceed to the next step.
5. Drill pilot holes using a drill bit, as specified in the drawing. For concrete or brick walls, insert
the concrete anchors making sure they are seated flush with the surface.
6. Align the wall plate with the holes drilled on the wall and hold it in place.
7. Insert the lag bolts and washers and tighten them firmly.
8. Place the bubble level on the center of the wall mount again, to check if the wall plate has
been positioned on the surface evenly.
Note:
The hardware provided is VESA compliant matching the whole specifications adopted by
the most widely known manufacturers of TV screens and monitors in the industry. However,
certain devices may require different sizes of screws and/or washers to attach the back panel to
the mount. Any additional hardware needed must be supplied separately by the user.
2. Tools required for installation
• Pencil
• Phillips screwdriver
• Stud finder for drywall installation
• Electric drill and masonry bit for concrete/brick installation (Please, refer to drawing for drill
bit size).
55mm
(
2.2"
)
ø 4.5
m
m
(
ø 3 /16
)
"
Label
M-F
W-A
W-B
W-C
Item
Long round spacer
Lag bolt
Concrete anchor
Metal flat washer
Quantity
8
4
4
4
Image
Installation on wood surface
Summary of Contents for KTM-351
Page 12: ...Notas Notes Notas Notes...
