Page 16 of
21
Version 1.0
© KLING & FREITAG GMBH
User's Manual
CA 106 PRO
1.0
23.10.2020
10/23/20
K&F
9
Wiring
HINWEIS
•
Before connecting your K&F CA 106 PRO speaker, switch off all devices and turn down all
faders and encoders.
•
Be sure to use high-end speaker cables with an appropriate wire gauge. Select the wire
size based on the cable length.
min. cable cross section (mm²) =
required cable length (m)
2 x speaker impedance (ohms)
•
To connect the mixing console to the power-amp inputs, use shielded 2-pole balanced mi-
crophone cables equipped with quality connectors.
•
Avoid creating ground loops.
•
Be sure to follow the pinouts shown in this manual.
•
Check for correct polarity of the speaker links to the power amplifier.
•
Upon completing wiring, ensure that the connected speaker channels are working in
phase, for example, using a phase tester. When the connected channels are used simulta-
neously, you can identify out-of-phase statuses by bass cancellation or mid-frequency
signals (e.g. voices) that cannot be located properly.
•
When connecting multiple speakers, you can daisy-chain the signal from one speaker to
the next. Make sure that the total impedance of all speakers connected to an amplifier
does not fall below the minimum impedance specified for the amplifier.
1
+
1
+
1
+ ... =
1
R1
R2
R3
R
(total)
WARNUNG
Speaker-signal currents are potentially hazardous to the human body.
When the system is in use, make sure that the connectors are secured against inadvertent
touch.
Summary of Contents for CA 106 PRO
Page 1: ...EN VERSION 1 0 10 23 20 USER S MANUAL K F CA 106 PRO...
Page 2: ......
