18
SMOKE CONTROL DAMPERS
MAINTENANCE AND
OPERATION
Klimaoprema smoke control damper are designed with fully
enclosed drive mechanism outside of the duct and as such do
not require cleaning and regular maintenance.
However, activation mechanism should be inspected for proper
operation on regular basis.
MAINTENANCE
COMMISSIONING
1) Carefully unpack FDSD smoke control damper - be careful
of sharp edges and do not use excessive force for unpacking
2) Inspect the smoke control damper - check the damper for
damage
3) Installation of the smoke control damper - according to the
installation instructions (
)
4) Before commissioning check the smoke control damper
functions
TRANSPORT
After arrival, check the smoke control damper for transport
damage and shortcomings. In case of any damage or
shortcomings, immediately contact your supplier.
STORAGE
If the damper is not installed immediately:
•
Remove any wrapping.
•
Protect smoke control damper from dust and
contamination.
•
Do not expose the smoke control damper to the
effects of weather - store damper in a dry place.
•
Do not store the unit below -20 °C or above 50 °C.
Please properly dispose of packaging material!
•
Provide at least one annual check of the damper
•
After each intervention, provide a systematic cleaning of
dust and especially the solenoid and its movable plate
•
Check the if the electrical terminals are tightened
•
Cleaning instruction: clean with a sponge, with water or a
mild detergent
•
Disinfection instruction: spray disinfectant (desinfectant
may contain alcohol which is flammable, take precaution
to avoid ignition)
It is not permitted to alter the dampers in any way nor perform
any changes to their structure (except for the service procedures
described in this manual) without the manufacturer’s consent.
Provide at least one annual check of the damper. The functional
test must be carried out in compliance with the basic
maintenance principles of the European norms EN 13306, EN
15423 and EN15650.
