5
STEAM FUNCTION SETTING
After turning the power on, set the temperature dial to the steam ironing position
(the area between Wool and Max on the temperature dial). The heating indicator light
will turn on with the iron unit, this indicates the unit being heated up. When the
desired temperature has been reached, the heating indicator light will turn off, once
this happens the iron is now ready for using. During use, the heating indicator light
will cycle from ON to OFF and then OFF to ON. This indicates that the iron is heat
regulating automatically. Press the steam button to start steam ironing. When you
adjust the temperature control dial, the steam rate will be adjusted accordingly.
FILLING THE WATER TANK
Step 1 -
Press the water tank lock upwards and slide
the detachable water tank outwards from the base.
(Fig. 2)
Step 2 -
Take the filter upwards out from the water
fill hole. (You can take the filter out of the opening
for filling water into water tank, or fill water into
water tank directly with the filter existing in the
opening). (Fig. 3)
Step 3 -
Fill the water tank up to or below the MAX
fill line with clean tap water. (Fig. 4)
Step 4 -
Replace filter back into water tank. When
moving please hold the water tank with two hands.
(Fig. 5)
Step 5 -
Replace the water tank into the base unit
again. You will hear a “Click” sound once the base
unit is securely locked in. (Fig. 6)
Step 6 -
Always pour out the remaining water after
use. (Fig. 7)
NOTE:
When the temperature control dial is located at Synthetic, it is sugested not to activate
steam ironing since temperature is too low to produce steam. this is only suited for dry ironing.
FIG. 2
FIG. 6
FIG. 3
FIG. 4
FIG. 5
FIG. 7
NOTE:
When the water level reaches a low level or
empty, the pump will provide a sound to indicate
refilling. You must stop using the appliance immediately
and refill the water tank as per instructions mentioned.
Note: *Water tank shown
