Warning!
• Read and understand the entire operator’s manual before using the pallet truck.
• Don’t load pallet truck beyond rated capacity of 11,000 lbs.
• Secure load before transporting.
• Keep the load centered on the pallet.
• Don’t operate loaded pallet truck on ramps or inclines.
• Always wear appropriate safety shoes.
• Never leave a loaded pallet truck unattended in the raised position;
always lower load to the floor.
Pallet truck assembly
Note:
Individual trucks are assembled and ready to use. Pallet trucks purchased in
crate quantities (6 units to a crate) require some assembly.
Tools needed for assembly:
hammer, flat screwdriver, 14mm wrench, 3/16" pin punch
*** IMPORTANT - SAFETY ***
Verify that spring safety pin is in place.
The pin should be well rested in the
holes situated on each side of the pump
housing. If the safety pin is not rested
properly in one of the holes, put pres-
sure on the spring using a “C" clamp
pushing down on the pump stem. Once
pressure is relieved on the pin, reinsert
properly and remove clamp slowly,
To attach handle assembly to the frame:
*** IMPORTANT - CHAIN****
Before this step, make sure to
feed the chain on the outside
of the piston stem roller (see
yellow arrow). If left in its proper
position, it will not be possible to
insert the handle pin and chain,
breakage may occur.
Align handle holes with pump
housing holes and push through
handle pin (see red arrow)
1.
Remove the handle pin as
shown.
3.
4.
Using a hammer and punch,
remove the spring pin.
2.
