RAMHD-734KIT6450
Installation and Operation Manual
PG 23/32
REV: A (08/05/2022)
2.
Attach Compressor to bracket, per above illustration.
b.
Use included fasteners.
i.
Tighten fasteners firmly.
3.
Attach 51414F 1/4” female compression fitting to end of air compressor hose, per above illustration
c.
d.
Hand-tighten each fitting, then further tighten each 1/4-1/2 turn using proper sized box-end
wrench; top plug requires hex wrench.
2019+ RAMHD:
For 2019+ RAMHD use the compressor bracket and bolt tie-plate to attach the compressor bracket to the frame.
Insert one end of the bolt tie-plate through the square hole. One bolt sticks out of this square hole, the other
bolt sticks out of the round hole just in front of it. Use your fingers to hold the tie plate against the inside of the
frame tube via the square thru-hole. Attach bracket to frame using bolt tie-plate and 7/16" hardware supplied,
as shown below.
Use one of the sets of slots as shown below. Use the forward set of slots (left image below) if your truck has the
rear floor-pockets.
2019+ RAMHD
