Klegg M6 501P, Manual

Page: 23 / 33

22
M6 501P Operation – Pro Logic Mode
Pro Logic Mode
power
balance
delay
prologic
field
EQ on/off EQ setup
preset 1 preset 2 preset 3
mute
Your M6 501P will automatically switch to Pro Logic
mode when it detects the Pro Logic signal. With
other signal inputs you can select the Dolby Pro
Logic mode by pressing Prologic Button on the
remote. Repeatedly pressing the Prologic Button will
cycle the Pro Logic mode in the order of: “ AUTO ”,
“ ALL PCM ”, “ ENABLE ” and “ DISABLE ”.
If a Pro Logic signal is detected the M6 501P will switch to Pro Logic mode automatically and
the following information is displayed:
D o l b y D i g i t a I C o
P R O L O G I C A U T O
If a Stereo signal (either in analog or in digital form) is detected the M6 501P will switch to
Stereo mode automatically. You can then convert the stereo signal to Pro Logic mode by
pressing the
Prologic Button until the display reads as follows:
D o l b y D i g i t a I C o
P R O L O G I C A L L P C M
or
D o l b y D i g i t a I C o
P R O L O G I C E N A B L E
In the case of converting a Pro Logic or 2-channel Dolby Digital signal into Stereo mode, press
the
Prologic Button until the display reads as follows:
D o l b y D i g i t a I C o
P R O L O G I C D I S A B L E