Kleenmaid MWK101X, Technical Instructions

Page: 3 / 16

TECHNICAL
FEATURES
MICROWAVE OVEN
MWK101X
MWK101X1
P32CKL11I
8X0744
10/2007
TF 1/1
Brandt Customer Services
AFTER SALES SERVICE DATA
•
Operating instructions : -87x6884
•
Servicing guide : -
OVERALL DESCRIPTION
•
Date of manufacture : 08/2007-
•
Type : Electronic
•
Cavity : Inox
•
Colour : INOX
CHARACTERISTICS
•
Power supply : - 220V / 50 Hz
•
Current density : - 15A
•
Maximum consumption : - 2750Wh
•
Grill power : -1250 W
•
Hot air power : - W
•
Microwave maximum power returned (CEI) : -1550 W
•
Weight bare : 27- kg
•
Volume : -30 l
•
Lamp : -25 W
DIMENSIONS
Overall Inside Building-in
Height 360- mm 254- mm 450- mm
Width 540- mm 350- mm 600- mm
Depth 410- mm 350- mm 550- mm
SAFETY
3. The primary and secondary microswitches control the
door closing and stop wave emission if the door is
opened.
4. If the primary safety microswitch fails, the control
locking contact produces a short-circuit and the fuse
melts :
•
MAGNETRON : cut off in case of overheating at
130°C.
•
OVEN : protected by a 12 A fuse.
•
GRILL : cut off in case of overheating at 100°C.
WARNING !
MICROWAVE RADIATION.
DO NOT EXPOSE YOURSELF TO THE MICROWAVE
GENERATOR RADIATION OR OTHER PARTS UNDER
MICROWAVE ENERGY.
Measuring microwave leaks is a must before and after any
service on the microwave oven.
It is absolutely forbidden to cancel the securities fitted to the
door.
All inlet and outlet microwave connections, wave guides,
flanges and gaskets must be safe.
Never use the appliance without a load absorbing the
microwaves (water).
Never look into a wave guide or open antenna while the
appliance is working.
DANGER HIGH VOLTAGE
In the high voltage area, there is a voltage higher than 4000
volts.
The hood must not be removed when the supply cord is
connected to the wall socket.
The oven must not be operated if the hood is removed.
Wait at least 30 seconds after disconnecting the oven, then
short-circuit the terminals using pliers with insulated handles
before disconnecting the H.V. capacitor.
WARNING !
When servicing with the need to cut off the trap (under the
motor plate), please replace this trap using the ref. 76X7754
screws.