5.1.9 Fan
Remove front panel and bearing shield (5.1.6). Remove fan front
cover to access fan. Fan is located on front of motor shaft, which has
left-handed thread. To remove fan from motor shaft, use a 1” wrench
and rotate fan (clockwise) from left to right.
When removing fan, hold motor shaft, not motor rotor fins, to avoid
damaging fins.
5.1.10 Anti Crease/end light
If the A
nti Crease/end
light is on while the display is off, an internal
switch (S3) on the control board has been damaged and the entire
control module has to be replaced.
5.1.11 Serial # (E-Nr) label
The serial # label is located below the door and shows the model (E-
Nr) and serial # of the dryer.
Turn cw to loosen (left-handed thread)
702_58300000135249_ara_en_a
Page 12 of 21