11
37005
Installations . . .
Standpipe Installation
Place washer in its location.
Place only the smooth end of the
drain hose into the standpipe. DO
NOT, under any circumstances,
place any ribbed portion of the
drain hose into the standpipe!
IMPORTANT: Drain receptacle
must be capable of handling a
minimum of 1-1/4 inch (3.175 cm)
outside diameter drain hose and
the recommended standpipe
height is 36 inches (91.44 cm).
Remove the beaded tie-down
strap from accessories bag and
place around standpipe and drain
hose, approximately 12 inches
(30.489 cm) down from the top of
pipe and tighten strap to hold
hose to standpipe. This will
prevent the drain hose from
dislodging from drain receptacle
during use.
Low Standpipe
Installation
NOTE: No. 562P3 Siphon Break
Kit is required for this type of
installation. This kit is available
(as optional equipment at extra
cost) through an authorized
dealer or parts distributor.
Installation instructions are
supplied with the kit.
OPTIONAL: Raise the standpipe
to the height of the cabinet top.
High Standpipe
Installation
NOTE: No. 562P3 Siphon Break
Kit is not required for this type of
installation.
W175IE2A
DRAIN HOSE
SLEEVE
12"
(30.489
cm)
36"
(91.44 cm
Recommended
Height)
STANDPIPE
2" (5.08 cm)
TIE-DOWN
STRAP
W174IE2A
562P3
SIPHON BREAK
KIT
OPTIONAL
(Raise standpipe)
DRAIN
HOSE
STANDPIPE
W176IE2A
DRAIN
HOSE
TIE-DOWN
STRAP
STANDPIPE
(Standpipes higher
than 4 feet [122 cm]
are not
recommended)
