Kleenmaid Dishwasher Collection, Instructions For Use Manual

Page: 7 / 28

aus
7
Adding rinse aid
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic
dishwashers.
Open the cover on the rinse-aid
dispenser
28
. To do this, press the
mark (1 ) on the cover and
simultaneously lift the cover on the
control plate (2 ).
Carefully pour in the rinse aid to just
below the edge of the filler opening.
Close the lid, ensuring that you hear it
snap closed.
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a cloth.
Adjusting the amount of
rinse-aid
The amount of rinse-aid added to the
water can be varied by adjusting the
stepless control. The rinse-aid control has
been set to ”4” in the factory.
Do not alter the setting of the rinse-aid
control unless streaks (turn knob towards
”–”) or water marks (turn knob towards ”+”)
are left on the dishes.
28
Rinse aid controller
Rinse-aid refill indicator
As soon as the rinse-aid refill indicator
lights up on the control panel
6
,
refill with rinse aid.
Switching the rinse-aid refill
indicator off or on*
*
some models
You can switch off the rinse-aid refill
indicator
6
if you use a detergent
with integrated rinse-aid.
Close the door.
Press and hold down button A .
Press main switch
1
until the digital
display lights up.
Release both buttons.
The digital display
7
indicates
(rinse-aid refill indicator) and the button
A flashes.
By pressing button A you can switch
the rinse-aid indicator off
or on .
Switch off the main switch
1
;
The setting is saved.
“Remember to switch on the rinse-aid refill
indicator again if you use a detergent
without an integrated rinse-aid!”