16
KLAXON Mobility GmbH - EN
KLICK devices - End User’s Manual (EN) - rev.7.2 of 2021.11.25
DANGER
Before using the reverse gear to move the device, make sure that there are no persons, obstacles,
stairs, slopes behind the wheelchair.
DANGER
At each restart pay maximum attention, before accelerating, to check if the forward or reverse
gear is currently selected, especially when close to obstacles, drop-offs and any other kind of
danger.
DANGER
If obstacles, drop-offs and dangers are too close to be safe, turn off the KLICK device and
manually move the wheelchair to a safe place.
CAUTION
Always apply the correct force to the brakes. Squeezing too hard the lever may cause the front
wheel blockage. This will increase the braking distance and compromise the overall stability.
13. INSTRUCTIONS FOR THE TETRA
HANDLEBAR VERSION
Figure 28 shows the Tetra handlebar of the Klick device and it identifies the elements that make it up (listed below).
1.
Handlebar
2.
Multi-function control panel (Figure 14) with the Intelligent Cruise Control button (A) and Reverse Gear
switch (B).
3.
Display
4.
EBS Button
5.
Display push-buttons panel (Figure 19 ) with “
M
” button (A), “
+
” button (B), “
-
” button (C) and “
POWER
“ button (D)
Once the device has been installed, the battery and the display have been turned on and a speed has been selected,
use the handlebar (pulling it toward you) to make the device start to move (Figure 29). To slow down the device’s
speed, activate the brake system by pushing the handlebar forward (Figure 30) or press the “
EBS BUTTON
” (the
red button in Figure 20). To stop the device keep pushing the handlebar forward until the KLICK stops completely
(Figure 30). The KLICK brake is equipped with an additional safety device that deactivates the motor and activates
the EBS when the handlebar is pushed forward (Figure 30).
The device is equipped with a reverse gear as standard equipment. To use the reverse:
A.
Move the switch to the right until is located under the “
RIGHT ARROW SYMBOL
” (Figure 22). A flashing
“
R
” symbol will appear on the display.
B.
Operate the accelerator, by pulling it toward you, until it reaches the maximum speed position. This will
activate the reverse gear.
C.
Release the tetra handlebar so that it returns to the neutral position.
D.
Gently activate the accelerator to start moving backward.
DANGER
If the brake has been activated while the reverse gear is engaged, the only way to re-activate the
backward movement is to repeat the procedure in this chapter (chapter 13) starting from step B.
This is due to safety reasons.
To return to the forward gear, release the accelerator and move to the left the switch until it is located in the centre
or under the “
LEFT ARROW SYMBOL
” (Figure 23).
CAUTION
The reverse gear has a warning system to show whether it is selected or not.
The warning is delivered in two ways:
VISUAL-> when the switch is located in the centre or under the “
LEFT ARROW SYMBOL
” the reverse
gear is DISENGAGED; when the switch is located under the “
RIGHT ARROW SYMBOL
” the reverse
gear is ENGAGED. A flashing “
R
” symbol will appear on the display when the reverse gear is engaged.
ACOUSTIC-> when the reverse gear is ENGAGED, the display will emit an acoustic warning that
will be active for all the duration.
CAUTION
After inserting the battery in its housing and locked by turning the key, remove the key and put
it in a safe place. It is absolutely forbidden to use the KLICK device with the key inserted in the
security block.
