27
10
MODE
Press this button, you can select the running mode as follows: AUTO > COOL > DRY > HEAT >
FAN. Note: HEAT mode is not available for cool only units.
11
SLEEP
Press this button to enter SLEEP mode, which the unit will exit after 10 hours of continuous
operation and restore to the previous status. Note:The SLEEP function cannot be activated in
FAN mode.
12
SWING
Press this button to activate up/down swing and press it again to fix the swing position.
13
SWING
Press this button to activate left/right swing and press it again to fix the swing position.
14
Anti-F
•
The Anti-F functions when the unit is turned off with the remote controller in COOL, DRY or
AUTO mode. It will operate in HEAT mode (FAN mode for cool only units), with the internal
fan running with weak flow for 3 minute before stop, to remove the moisture within the
evaporator so as to prevent it from giving off bad smell from mold.
• This function is not set in the factory. You may set it or cancel it any time you want as
follows: With both the unit and the remote controller OFF, point the remote controller at the
unit and press “Anti-F” button once, the buzzer will sound 5 times after 5 times, indicating
this function is set. Once set, this function will remain valid except when the unit is power off
or until it is canceled.
•
To cancel Anti-F: Power off the unit. With both the unit and the remote controller OFF, point
the remote controller at the unit and press this button once, the buzzer will sound 3 times
after 5 times, indicating this function is canceled.
•
Note: With Anti-F activated, it is advised not to turn ON the unit again before it is fully OFF.
Anti-F function will be invalid when OFF timer is set.
15
ELE.H
If this button is pressed in HEAT mode, the electric heating will be turned on/off.
ECO
If this button is pressed in COOL mode, the unit will enter the ECO mode which has the lowest
electricity consumption, and exit it automatically 8 hours after. Changing modes or turning off
the remote controller will automatically cancel the ECO function. Press ECO button in ECO
mode to exit this mode. Note: The ECO mode only works for inverter units.
Automatic operation mode
• Press the “MODE” button, select the automatic operation mode.
• By pressing the “SPEED” button, you can select the fan speed from LOW, MID, HIGH, AUTO.
•
Press the “ON/OFF” button, the air-conditioner starts to operate.
•
Press the “ON/OFF” button again, the air-conditioner stops.
•
Note: In the fan operation mode, the temperature settings is non-effective.