40
EN
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has six or four settings. Always
start with the dispenser set on „4“. If spots and poor
drying are problems, increase the amount of rinse aid
dispensed by removing the dispenser lid and rotating
the dial to „5“. If the dishes still are not drying properly
or are spotted, adjust the dial to the next higher
number until your dishes are spot-free.
The recommended setting is „4“. Factory value is „4“.
Increase the dose if there are drops of water or lime
spots on the dishes after washing. Reduce it if there are
sticky whitish stains on your dishes or a bluish film on
glassware or knife blades.
Function of Detergents
Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and
transport it out of the dishwasher. Most of commercial quality detergents are suitable for
this purpose.
Normally new pulverised detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt container even
when the hardness of water is only 6 dH. If detergents without phosphate were used in
case of hard water often white spots appear at dishes and glasses. In this case please
add more detergent to reach better results. Detergents without chlorine do only bleach a
little. Strong and coloured spots will not removed completely. In this case please choose
a programme with higher Temperature.
Concentrated Detergents
Based on their chemical composition, dishwasher can be split in two basic types:
• Conventional, alkaline detergents with caustic components
• Low alkaline concentrated detergents with natural enzymes
