Klarstein 10032486, Manual, Page: 40 / 100

40
EN
Replacement Light
Ø Max Power Voltage Picture
ILCOS D
code
70 mm 1,5 W DC 12 V
DSR-
1.5-S-70
Reinstall LED Light Module
1 Press LED light on the front of front plate, install the LED light on the front plate.
2 Connect the terminal of LED light and light leads.
3
Carefully fasten the 2 screws on the front plate ,reinstall the grease filter.
TROUBLESHOOTING
Problem Cause Solution
Light on, but motor does
not work The blades are blocked. Check the blades.
The capacitor is damaged. Replace capacitor.
The motor is damaged. Replace motor.
The internal wiring f motor
is cut off/disconnected.
An unpleasant smell may
be produced.
Both light and motor do
not work Apart from the above mentioned, check the following:
Light damaged. Replace lights.
Power cord loose. Connect the wires as the
electric diagram.
Oil leakage Outlet and the air
ventilation entrance are
not tightly sealed. Take down the outlet and
seal with glue.