60
4. Under auto mode: the indoor fan operates at the auto quiet mode according to actual cooling, heating or
fan mode.
About Sleep function
Under the Fan and Auto mode, the Sleep function cannot be set up, under Dehumidify mode, only Sleep 1
can be selected. Select and enter into any kind of Sleep mode, the Quiet function will be attached and stared,
different Quiet status could be optional and turned off.
Operation
1. After putting through the power, press ON/OFF button on remote control to turn on the air conditioner.
2. Press the “MODE “button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press the “+” or “-” button to set your required temperature. (Temperature can’t be adjusted under auto
mode).
4. Press the “FAN” button to set your required fan speed: auto,
low, medium and high speed.
5. Press the and buttons to select fan blowing angle.
Replacement of batteries in remote control
1. Press the back side of remote control and then push out the
cover of the battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of “+” polar and “-” polar are correct.
3. Reinstall the cover of battery box.
Note:
• During operation, point the remote control signal sender at the receiving window on indoor unit.
• The distance between signal sender and receiving window should be no more than 8m, and there should
be no obstacles between them.
• Signal may be interfered easily in the room where there is a fluorescent lamp or wireless telephone; re-
mote control should be close to indoor unit during operation.
Emergency operation
If remote controller is lost or damaged, please use auxiliary button to turn on or turn off the air conditioner.
The operation in details are as below: conditioner. When the air conditioner is turned on, it will operate under
auto mode.
battery
Cover of battery box
remove
reinstall