57
In Heat mode
1. Under the initial temperature of 16 °C, it will run under this set temperature all along.
2. Under the initial presetting temperature 17-20 °C, after Sleep function started up, the temperature will
decrease 1 °C after one hour, afterwards this temperature will be maintained.
3. Under the initial presetting temperature 21-27 °C, after Sleep function started up, the temperature will
decrease 1 °C every hour, after 2 °C decreased, this temperature will be maintained.
4. Under the initial presetting temperature 28-30 °C, after Sleep function started up, the temperature will
decrease 1 °C every hour. After 3 °C decreased this temperature will be maintained.
Sleep 3
the sleep curve setting under Sleep mode by DIY.
1. Under Sleep 3 mode, press “Turbo” button for a long time, remote controller enters into user
individuation sleep setting status, at this time, the time of remote controller will display “1hour”, the
setting temperature “88” will display the corresponding temperature of last setting sleep curve and
blink (The first entering will display according to the initial curve setting value of original factory)
2. Adjust “+” and “-” button, could change the corresponding setting temperature, after adjusted, press
“Trubo” button for confirmation.
3. At this time, 1hour will be automatically increased at the timer postion on the remote controller, (that are
“2hours” or “3hours” or “8hours”), the place of setting temperature “88” will display the corresponding
temperature of last setting sleep curve and blink;
4. Repeat the above step (2)~(3) operation, until 8hours temperature setting finished, sleep curve setting
finished, at this time, the remote controller will resume the original timer display; temperature display
will resume to original setting temperature.
The sleep curve setting under Sleep mode by DIY could be inquired: The user could accord to sleep curve
setting method to inquire the presetting sleep curve, enter into user individuation sleep setting status, but do
not change the tem-perature, press “Turbo” button directly for confirmation.
Note: In the above presetting or enquiry procedure, if continuously within10s, there is no button
pressed, the sleep curve setting status will be automatically quit and resume to display the original
displaying. In the presetting or enquiry pr-ocedure, press “ON/OFF” button, “Mode” button, “Timer”
button or “Sleep” button, the sleep curve setting or enquiry status will quit similarly.