Klark Teknik DN32-DANTE, Quick Start Manual

Page: 13 / 59

24 25
Quick Start Guide DN32-DANTE
5.4 X32 with DN32-DANTE connection to
Midas PRO2 via CM1 Dante card
MIDAS M32
with DN32-DANTE
MIDAS Console
KLARK TEKNIK DN9650
Network of Dante-enabled equipment
Cat 5/6 Ethernet,
Dante network @48 kHz
Cat 5/6 AES50
@ 96 kHz
24 x 24 channels
Cat 5/6 Ethernet
@ 48 kHz Dante
32 x 32 channels
Router/Switch
Laptop
for configuration
routing and mixer
remote control
5.5 Two M32 consoles with DN32-DANTE
connection to DVS for recording
64 simultaneous tracks
• •
Both consoles need to have DN32-DANTE cards installed.
Connect one of the DN32-DANTE Ethernet ports on console A
with the card installed in console B.
• •
Connect the second port of console B, either directly with
the DAW-PC/Mac or via a network router to which the DAW
has access. This link will carry all 64 channels to and from
both consoles.
• •
Tip: The console’s Ethernet remote control can be done
over the same network. For remote controlling console A
in this example, it is sufficient to use a short patch cable
connecting console A’s Remote connector with the free port
on DN32-DANTE. Since both ports on DN32-DANTE of console
B are occupied already, you would need to patch a separate
cable to the network router.
• • Open the Dante Virtual Soundcard driver control panel and
switch it ON.
• • Run the Dante Controller application to configure the virtual
channel patch bay and route the channels between Dante
Virtual Soundcard and the consoles.
Two M32 consoles with DN32-DANTE connection to DVS for recording 64 simultaneous tracks
Midas M32
Console A
Laptop/DAW
Router
(optional)
Midas M32
Console B