14
15
Quick Start Guide
Klark Teknik DN32-ADAT
3. Connector Plate
•
•
Single BNC coaxial, in/output switchable,
no internal termination, LED indicates WC output
(Master mode)
• •
4x Toslink inputs and 4x Toslink outputs,
8 channels per connector
• •
2x small handles for removing the expansion card
from the slot
• •
2x M3x6 screws left and right for fastening the card in the slot
• •
2x small counter sunk screws below the handles and
8 screws above the connectors. Do not loosen these!
4. Connection Scenarios
DN32-ADAT external hard disc recorder
(providing Word Clock via BNC coaxial connection)
2x XL48 -> Midas M32
Midas M32 with DN32-ADAT
Hard disc recorder Recorder
Coaxial
Midas M32
Optical
Coaxial Word Clock
Optical
Midas XL48
Midas XL48
5. Mixer Setup
DN32-ADAT external automixer return to DN32-ADAT
• •
Out 1-8 and 9-16 to Auto-mixing Processor inputs
• •
In 1-8 and 9-16 from Auto-mixing Processor outputs
• •
Routing/home > Input 1-16 = Card In 1-16,
Routing/card out > Output 1-16 = Local 1-16
Note, this would also apply for any other sort of specialized
outboard processing that features ADAT I/O. It can be used for
all 32 x 32 channels simultaneously, even spread over several
external processors.
Auto mixer
Coaxial
Wordclock
Midas M32
Word clock I/O selector:
• •
either word clock slave (input), allowing the console to sync
to external WC devices or
• •
word clock master (output), providing system word clock to
other devices
DN32-ADAT card can be selected as the clock source on the
M32 Setup/config page. In this case, the mixer will be slaved to
the ADAT clock received on BNC input or fiber optic Toslink inputs.
Note that this may require the console to be rebooted if the
internal and external clock rates are different (i.e. 44.1/48 kHz).
Word clock selection box for choosing the external clock
synchronisation source:
• •
fiber optic inputs 1-4 or
• •
coaxial BNC WC input
• •
local clock indicates the console’s internal clock.
Summary of Contents for DN32-ADAT
Page 26: ......
