Klarfit Treppo, User Manual

Page: 33 / 44

33
EN
Attach the handlebar (36) to the upper main frame (51) with two screws (42),
two curved washers (47) and two nuts (49).
Note: Be careful not to squeeze the hand pulse cord ( 41).
Remove the two pre-assembled screws on the back of the bracket (40) and
fasten the bracket to the upper main frame (51) with the two screws. Connect
the cable on the back of the console (40) to the upper sensor cable ( 53). Plug
the hand pulse cable (41) into the socket (PULSE) on the back of the console
(40).
Inserting the batteries
Open the battery compartment on the back of the console (40).
Insert two batteries (1.5 V / AAA) into the battery compartment. Make sure
the polarity (+/-) is correct when inserting the batteries. A long beep sounds.-
Close the battery compartment and make sure the cover engages.
Step 4
Fasten the bottle cages (23) to
the upper main frame (51) using
two Phillips screws (54).
Make sure that all screws are
tightened firmly and that the
stepper stands on a flat surface.
Make sure that the hydraulic
cylinders are set to the same
resistance before starting the
exercise.