navigation lights (available on Pro 102 and Pro 120 models)
The lights should always be used if there are poor lighting conditions, e.g. dusk, dawn, fog etc. If you are anchored or not moving only the
stern light (sometimes called an all around light) should be on. If the boat is moving or underway both the bow lights and stern light must be
on. See Electrical Systems Overview for light installation instructions.
Traveling across the water
Do not be concerned if you notice a slight hull flexing during use. The boat is designed to flex and absorb minor bumps without damage.
This flexing is one of the great advantages of polyethylene.
Trim /Planing (all models)
The Pro 120 is designed with a planing hull. However it likely will not plane with less than a 9.9 HP motor. Two-cycle outboards generally
provide better performance on a small boat because they are lighter in weight than four-cycle motors.
The Pro 94 and Pro 102 models are not designed to plane. However, they will travel smoothly if loaded and trimmed properly.
With most outboard motors, you can adjust the trim. This is the angle between the power unit of the motor (prop) and the transom of the
boat. If the motor is angled out too far, the bow will rise sharply when power is applied. When the prop is angled too close to the transom, it
will tend to push the bow down when power is applied.
Adjusting the weight distribution in the boat will also help the boat travel smoothly. If the bow lifts too much, shift more
of the weight forward. If the bow tends to plow down in the water, shift weight toward the stern.
TransPOrTInG
Transporting by Pickup Truck
All models can be conveniently transported in the back of a full size pickup truck. Be sure to tie the boat down snugly
using several tie down straps. Do not over tighten the straps. This will distort the deck and hull.
Trailering
If your boat will be transported on a trailer here are some important considerations. See Photos #4 & #5.
• Ensure that the trailer has supporting bunks that are 5’ to 8’ long. They should be made from 2” x 4” or 2” x 6”
stock turned wide side up. If the trailer doesn’t have bunk supports this size, you’ll need to make them. Transporting
and especially storing a boat on a trailer with too short or too narrow supports will cause the hull to dent and will
Photo #4 Correct
Photo #5 Incorrect
