15
Using the dishwasher
3.6 Use of „3 in 1“ Detergent Tablets
General Advice
1. Before using these products you should first check that the water hard-ness in your
supply is compatible with the use of these products as per the detergent manufactu-
rers instructions (on the product packaging).
2. These products should be strictly used according to the detergent manufacturers
instructions.
3. If you encounter problems when using „3 in 1“ products for the first time then please
contact the detergent manufacturers care line (the telephone number is given on the
product packaging).
You find information about the amount of detergent for the single program-
me on the last page. Please be aware that according to the level soiling and
the specific hardness of water, differences are possible.Please observe the
manufacturer‘s recommendations on the detergent packaging.
Tip:
When using combination products, the rinse-aid and salt lights are no longer useful.
It may be helpful to select the lowest possible setting for water hardness
To select „3-in-1“ function
1. Press the power switch and select the 3in1 washing cycle by pressing the button „
ALT“ until the „3in1“ indicator blinks.
2. The 3in1 washing cycle will be available after pressing the start/pause button , and
the“3in1“ indicator lights.
To cancel „3-in-1“ function
1. Follow the ‚Cancelling a programme in progress‘ instructions.If you decide to switch
to the use of a standard detergent system we advise that you: 1. Refill both the salt
and rinse aid compartments
2. Switch the water hardness setting to the highest possible position and run for three
normal cycles without load
3. Readjust the water hardness setting again according to the conditions for your regi-
on (For more information please refer to your instruction manual).
Note:
3in1 washing cycle is additional function, they must be used with other pro-
gramme (Intensive, Eco and Light).
EN