39
EN
Care and cleaning
Removing the slide-in racks
To make it easier to clean the side walls of the cooking cham-
ber, you can remove the slide-in racks:
• Remove accessories such as grate and baking tray.
• Slightly press down the slide-in rack at the clamping point (
1
)
and pull it away from the oven wall.
• Swing the slide-in rack inwards and unhook it at the top (
2
).
Inserting the slide-in racks
• Hook the rack into the holes at the top (
2
) and swing it
towards the side wall of the cooking chamber.
• Slightly press down the rack bar at the clamping point (
1
)
and push the rack towards the side wall.
•
The slide-in rack must snap into place and be firmly seated.
Changing the oven light bulb
In the lamp bulb is a particularly heat-resistant mold
(230 V, 25 W).
To replace this, proceed as follows:
• In any case disconnect the appliance from the power
supply (pull the plug or remove the fuse), because the
socket could be live.
• Unscrew the glass cover.
• Unscrew the bulb and replace it with a new one of the same
type (see figure at right).
• Screw back the cover glass.
Telescopic pull-out rails
For cleaning the slide-in racks the telescopic pull-out rails
can be removed.
•
Loosen the fixing screws with a large screwdriver and
remove the complete set.
• Only clean the telescopic pull-out rails from the outside
with commercially available cleaning agents.
Do not immerse the telescopic pull-out rails in water or
clean them in a dishwasher!
•
After cleaning, put on the telescopic pull-out rails and fas
-
ten them again at the bottom with the screws.
Caution!
The rollers must not be greased.
!
2
1
Summary of Contents for BO8810SS
Page 22: ......
Page 23: ...EN User s manual for your built in electric oven Model BO8810SS Version 1 0 200518...
Page 43: ......
