5
IV. Basic Settings
Click
[System Maintenance] to enter the setting menu(
necessary settings are
marked in Blue
):
Clock
Manual time: Select Time Zone(UTC) > Click Apply > Set Date & Time.
Auto time: Tick the Auto Time check box > fill out IP address of a preferred time server > click Apply.
Users
Add/Delete/Modify user information including User ID, Card numbers
(Card numbers are used
for identifying users and their enrolled fingerprints. It can be the number of an actual RF card, or
you may make up a number for an user who is requested to use fingerprint only.)
, User Names,
Access PIN(default: 888888), User Group(if set as VIP the user will be allowed to
click the keyboard icon
on the bottom of PX2500’s main screen to pop up the keyboard and enter its
card number to open the door without reading its card or fingerprint), & User Validity.
A much
faster and more convenient way for User management is through your PX2500’s Self-contained
or PC-end web-interfaced software (for details please refer to p.8 & 15).
System
■
Network
For setting IP address, Sub-net Mask, Gateway & DHCP on/off while using
Ethernet cable. Once completed click [Apply] to save settings.
■
Record Option
For selecting required records & relevant rules:
In Record —
In / Clock In records of registered users.
Out Record — Out / Clock Out records of registered users.
Event Record — including all records other than the above two, such as records of unregistered users,
alarm, open-button, door open from software, etc.
Record Cycle — if enabled, new records will overwrite old records when PX2500 memory is full.
Unduplicate — once enabled PX2500 will stop recording the same card or fingerprint reading in the set
interval(inMinute).
5 Digit — this is a special feature designed for those who require the card reader to decode only 5 digits of
a card number. Ignore this if you are not sure about what this is!
■
Tamper Switch
If enabled, PX2500 will alarm in case of vicious destruction.
■
Calibration
Used for re-calibrating touch screen if touch point found imprecise. Steps to do:
1. Click [Re-calibrate].
2. A positioning cross will appear sequentially 5 times. Press on the centers of these crosses using your
finger tip or a stylus precisely until you finish all the 5 crosses. Double-click on the blank screen to complete
the procedure.
■
Beep Hints