BUILD INSTRUCTIONS
2
1
3
Remove the horn from
the servo and follow
the diagram to
assemble the rest
of your Klaw.
4
Attach to your :MOVE Motor using the M4 bolt
into the mounting hole as shown below, then
connect the servo lead to one of the servo pin
headers on the :MOVE Motor. You can mount the
Klaw vertically or horizontally based on which
mounting hole you use.
Note:
There are two
kinds of Klaw in this
kit! Swap out this pincer
to switch between builds
(see step 4).
a
b
a
b
Take care not to damage
the servos wires when
tightening these screws!
Visit www.kitronik.co.uk/5696 for coding tutorials!
Check these screws are
loose enough that the
pincers can rotate freely.
Connect a horn to the servo axle
and gently rotate clockwise until it
stops. Then rotate back an 1/8 turn.
3
