12
(5) Insert two sets of Spring Lock
Washers and Socket Head Cap
Screws on the lower side of Frame
A/B and tighten temporarily them,
and then secure all the four screws
in order of
①
,
②
,
③
and
④
with
the specific torque.
Ensure that the Road Sheave
rotates smoothly.
Tightening torque: 7 to 8N•m
(6) Attach the Load Gear to the Load
Sheave. Apply specified amount of
grease to the specified position of
the Pinion and insert the Pinion in
and out of the Load Sheave a few
times.
Automotive wheel bearing grease
·Rated load 0.25t :0.7g
·Rated load 0.5t :0.9g
Load Gear
Load Sheeve
Pinion
Grease
Gear #2
Socket Head Cap
Screw
Spring Lock Washer
4 mm
Torque
Grease
(7) Apply the grease to Gear #2, and
then assemble two of Gears #2 with
the "O" and "V" marks set as shown
in the bottom figure.
Automotive wheel bearing grease
·Rated load 0.25t :0.2g
·Rated load 0.5t :0.3g
(4) Align the projecting part of the Chain
Guide with the notch of the Body,
and assemble the Chain Guide to
the bottom of the Body Assembly.
Chain Guide
Protrution
and notch
(Continued on the following page)
Gear cross section
Pinion
Gear #2
Gear #2
