14
Install Lower Chimney Cover
1.
Slightly spread the sides of the cover apart and hook
them behind the upper chimney.
2.
Secure the lower chimney covers to the range hood
canopy using 4 - 4.2 x 8 mm screws.
Complete Installation and Check
Operation
1.
Install grease filters. See “Range Hood Care” section.
2.
Check operation of the range hood blower and lights.
See “Range Hood Use” section.
3.
If range hood does not operate, check to see whether
a circuit breaker has tripped or a household fuse has
blown. Disconnect power supply and check that the
wiring is correct.
NOTE:
To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
range hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen.
The range hood controls are located on the underside of the
range hood.
Range Hood Controls
Operating the light
1.
Move the light switch to the “1” position to turn range hood
light to night light setting.
2.
Move the light switch to the “2” position to turn range hood
light to full light setting.
3.
Move the light switch to the “Off” position to turn range hood
light Off.
Operating the fan
1.
Move the fan switch to the “On” position to turn the fan
On. The fan will begin operating at the speed set on the
fan speed switch.
2.
Move the fan switch to the “Off” position to turn the fan Off.
Auto On Fan
The range hood is equipped with a sensor to automatically
turn on the fan when excessive heat is detected in the control
area. When the fan switch is in the “Off” position, this sensor
will turn the fan to high speed when necessary. When the heat
decreases, the fan will turn Off.
When the fan switch is in the “On” position, the heat sensor is
not active and the range hood functions normally.
Adjusting the fan
The fan has 3 speed controls. Move the fan speed switch to “1”
position for low speed, “2” position for medium speed, or “3”
position for high speed.
Thermal Protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move fan slider switch to “Off” to turn off the range hood. Wait
approximately 60 minutes, then move slider to “On” to restart
the range hood.
A. Lower chimney covers
B. Range hood canopy
C. 4 - 4.2 x 8 mm screws
A
B
C
D
E
F
G
A. Halogen lights
B. Blower control switches
C. Halogen light switch
D. Heat lamp switch
E. Heat lamps
F. Grease filter
G. Grease filter handles
A
B
C
A. Light control
B. Blower control
C. Fan speed control
