![background image](http://html.mh-extra.com/html/kitchenaid/ksdg950ess2/ksdg950ess2_installation-instructions-manual_198316023.webp)
23
6.
Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
A
B
C
A
A. Metal cover
B. Washer
C. Blue regulator cap
7.
Flip the blue regulator cap over and screw it back into
the metal cover.
A
B
8.
Screw the metal cover securely back into place.
Do not overtighten.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1.
If installed, remove the burner grates.
2.
Remove the burner caps.
3.
Remove the burner base.
D
A
B
C
A. Natural gas position
B. Propane gas position
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
4.
Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
A
B
C
D
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
5.
Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
A
A. Propane groove
NOTE:
Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door
for proper sizing of spuds for each burner location.
6.
Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
7.
Replace the burner base.
8.
Replace burner cap.
9.
Repeat steps 1 to 7 for the remaining burners.
A
B
C
A. Burner cap
B. Burner base
C. Choke (for use with large burner,
propane gas only)
Large Burner
Refer to the following chart for correct Propane gas orifice spud
ratings and to spud holder card for proper placement.
Fully insert choke into bottom of large burner base. Choke
should snap into place.
NOTE:
Use only for spreader bases marked “L”.
Propane Gas Orifice Spud Chart for Surface Burners
Placement
Burner
Rating/Type
Size (mm)
ID Number
LF
14,200 BTU
1.08
108AM
LR
5,000 BTU
0.64
064AM
RF
14,200 BTU
1.08
108AM
RR
8,000 BTU
0.84
084AM
CTR
8,000 BTU
0.84
084AM