KitchenAid KRSC503ESS, Installation Instructions And Owner'S Manual

Page: 5 / 64

5
Door Swing Dimensions
■
Location must permit doors to open to a minimum of 165°.
■
In the following graphic, “A” represents the distance needed
to fully open the freezer door and “B” represents the distance
needed to fully open the refrigerator door.
*Dimension may vary based on style of door handle.
The width for the largest available handle is listed.
Location Requirements
NOTES:
■
The refrigerator can be installed into a recessed opening, at
the end of cabinets or as a freestanding refrigerator.
■
If you are installing the refrigerator to fit flush with the front of
the base cabinets, all shoe moulding and baseboards must be
removed from the rear of the refrigerator opening. Allow for
1" (2.54 cm) of space behind the refrigerator.
■
Location should permit doors to open fully. See “Product
Dimensions.”
■
This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 55°F (13°C) to a
maximum of 110°F (43°C). The preferred room temperature
range for optimum performance, which reduces electricity
usage and provides superior cooling, is between 60°F (15°C)
and 90°F (32°C). It is recommended that you do not install the
refrigerator near a heat source, such as an oven or radiator.
■
Floor must support refrigerator weight (more than 600 lbs
[272 kg]) and contents.
Electrical Requirements
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE:
Before performing any type of installation or cleaning, or
removing a light bulb, turn cooling off or turn the control
(Thermostat, Refrigerator or Freezer Control depending on the
model) to OFF, and then disconnect the refrigerator from the
electrical source. When you are finished, reconnect the
refrigerator to the electrical source and turn cooling on or reset the
control (Thermostat, Refrigerator or Freezer Control depending on
the model) to the desired setting. See “Using the Controls” in the
User Instructions, User Guide, or Use & Care Guide.
Dimension Flat Doors Curved Doors
A
13 ⁵⁄₈ " (34.5 cm)
maximum*
13 ³⁄₄ " (34.9 cm)
B
18 ¹⁄₈ " (46.0 cm)
maximum*
18 ³⁄₈ " (46.4 cm)
C
2 ³⁄₄ " (6.7 cm)
maximum*
3 ³⁄₄ " (9.4 cm)
D
¹⁄₈ " (0.2 cm) 1 ¹⁄₄ " (2.9 cm)
A
41
¹⁄₄
" (104.5 cm)
C
D
B
45
⁷⁄₈
" (116.4 cm)
90˚
165˚
C
D
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING