11
Installing the Produce Preserver (on some models)
The Produce Preserver pouches should be installed in their
housing, which is located along an interior side wall of the crisper
or convertible drawer.
NOTE:
For best performance, always use two pouches.
1.
Remove the Produce Preserver pouches from their packaging.
2.
Lift up on the housing in order to remove it from its mounting
tab along the wall.
3.
Open the housing by pulling up and out on the back of the top
of the housing.
4.
Place both pouches inside the housing, then snap the housing
back together.
5.
Place the housing back on the mounting tab along the wall.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which
should be activated and installed at the same time the pouch is
installed.
1.
Place the indicator face-down on a firm, flat surface.
2.
Apply pressure to the bubble on the back of the indicator, until
the bubble pops to activate the indicator.
3.
Slide open the cap on the Produce Preserver housing.
4.
Place the indicator in the top of the housing, facing outward.
5.
Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE:
The cap will not easily close if the indicator’s rear
bubble has not been popped.
Replacing the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
To order replacements, see “Accessories” in the User Instructions
or User Guide.
1.
Remove the old pouches from the Produce Preserver housing.
2.
Remove the old status indicator.
3.
Install the new pouches and status indicator using the
instructions in the previous sections.
Changing the Water Filter
The water filter status light will help you know when to change
your water filter. See “Water Filtration System” in the User
Instructions or User Guide.
NOTE:
If water flow to your water dispenser or ice maker
decreases noticeably, change the filter sooner. The filter should be
replaced at least every 6 months, depending on your water quality
and usage.
1.
Locate the water filter in the top-right corner of the refrigerator
compartment.
2.
Lift open the filter cover door. The filter will be released and
then be ejected as the door is opened.
3.
When the door is completely open, pull the filter straight out.
NOTE:
There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
4.
Take the new filter out of its packaging and remove the cap.
Be sure the O-rings are still in place after the cap is removed.
5.
With the arrow pointing up, align the new filter with the filter
housing and slide it into place. The filter cover door will
automatically begin to close as the new filter is inserted.
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium
permanganate. If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.
CA
UTION
IR
R
IT
A
N
T
Read cautions on bac
k.
A
TTENTION
IR
R
IT
A
N
T
Lisez des pr
udences sur le re
v
e
rs
.
A. Cap
B. O-rings
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
B
B
A
Summary of Contents for KRSC503ESS
Page 21: ...21 Notes ...
