![background image](http://html.mh-extra.com/html/kitchenaid/kfgg500ewh/kfgg500ewh_owners-manual_198253020.webp)
20
3.
Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4.
Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number and
have a groove in the hex area. Replace the Natural gas orifice
spud with the correct propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas orifice
spud placement.
Propane Gas Orifice Spud Chart for Surface Burner
Placement
Burner Rating
/ Type
Size (mm)
ID Number
LF
14,200 BTU
1.08
108AM
LR
8,000 BTU
0.84
084AM
RF
14,200 BTU
1.08
108AM
RR
5,000 BTU
0.64
064AM
CTR
8,000 BTU
0.84
084AM
NOTE:
Refer to the model/serial/rating plate located on the oven
frame behind the top left side of the oven door for proper sizing of
spuds for each burner location.
5.
Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
6.
Replace the burner base.
7.
Replace burner cap.
8.
Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Natural Gas to
Propane Gas)
1.
Remove the oven racks.
2.
Remove 2 screws at the rear of the oven bottom.
3.
Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Screws
B. Oven bottom
4.
Remove 1 screw from the bake burner.
5.
Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the oven
orifice, and set the bake burner aside.
A. Screws
B. Bake burner
6.
Use
a
3/8"
(1
cm)
nut
driver
or
combination
wrench
and
turn
the
Natural
gas
bake
burner
orifice
spud
counterclockwise
to
remove.
The
spud
will
be
stamped
with
a
“47.”
7.
Replace
the
“47”
spud
with
a
“56”
spud.
Install
the
Propane
gas
bake
burner
orifice
spud,
turning
it
clockwise
until
snug.
IMPORTANT:
Do
not
overtighten.
A. Orifice spud
Summary of Contents for KFGG500EWH
Page 52: ...Remarques 52 ...
Page 53: ...53 Remarques ...
Page 54: ...Remarques 54 ...
Page 55: ...55 Remarques ...