7
Assembling Your Bowl-Lift Stand Mixer
Pre-Use Cleaning
Before using your stand mixer for the first
time, wash the mixing bowl and accessories
(see “Care and Cleaning” section).
Attaching Mixing Bowl
1. Be sure speed control is OFF and mixer
is unplugged.
2. Place bowl lift handle in down position.
3. Fit bowl supports over locating pins.
4. Press down on back of bowl until
bowl pin snaps into spring latch.
5. Raise bowl before mixing.
6. Plug mixer in proper electrical outlet
(see “Electrical Requirements“ section).
Removing Mixing Bowl
1. Be sure speed control is OFF and mixer
is unplugged.
2. Place bowl lift handle in down
position.
3. Remove Flat Beater, Wire Whip*, or
Dough Hook*.
4. Grasp bowl handle and lift straight up
and off locating pins.
Raising Mixing Bowl
1. Rotate handle to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.
Lowering Mixing Bowl
1. Rotate handle back and down.
Attaching Flat Beater, Wire Whip*, or
Dough Hook*
1. Turn speed control to OFF and unplug.
2. Slip Flat Beater on beater shaft and
press upward as far as possible.
3. Turn beater to
right, hooking
beater over the
pin on shaft.
4. Plug mixer in
proper electrical outlet (see “Electrical
Requirements“ section).
Removing Flat Beater, Wire Whip*, or
Dough Hook*
1. Turn speed control to OFF and unplug.
2. Press beater upward as far as possible
and turn left.
3. Pull beater from beater shaft.
4. Plug mixer in proper electrical outlet
(see “Electrical Requirements“ section).
PIN
Solid State Speed Control
Off Stir 2 4 6 8 10
*Sold separately for model K4SS.
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
WARNING
RAISE
Summary of Contents for K4SS
Page 1: ...BOWL LIFT STAND MIXER INSTRUCTIONS AND RECIPES 1 800 541 6390 KitchenAid com W10171783D ...
Page 70: ...68 ...
Page 71: ...69 ...