EN
5
PRODUCT ASSEMBLY (CONTINUED)
ATTACHING THE DRIVE ASSEMBLY FOR TILT-HEAD STAND
MIXERS
1.
Be sure the Stand Mixer is OFF (0) and unplugged. Keep the motor head tilted back and
put the Dasher and Freeze Bowl into place.
2.
Place Drive Assembly onto the Stand Mixer, aligning the cutout with the Stand Mixer shaft.
3.
Lower the motor head to engage the Drive Assembly with the Dasher. If the Drive
Assembly doesn’t engage the Dasher, slide the Drive Assembly either back or forward
until it does engage the Dasher properly.
4.
Make sure the motor head is down completely.
5.
Place locking lever in the
position. Before mixing, test the lock by attempting to raise the
motor head.
WARNING
Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
6.
Plug the Stand Mixer into an earthed outlet.
ATTACHING THE ICE CREAM MAKER FOR BOWL-LIFT STAND
MIXERS
Before first use
Before using your attachment, remove the “Do not immerse in water” label. The Freeze Bowl,
Dasher, and Drive Assembly must be washed by hand.
1.
Turn Stand Mixer OFF (0) and unplug.
2.
Place bowl-lift handle in down position and remove mixing Bowl.
IMPORTANT:
Do not pour ice cream batter into the Freeze Bowl until all parts are
assembled and the Stand Mixer is running.
NOTE:
Use the Freeze Bowl immediately upon removal from freezer, as it begins to thaw
once removed.
3.
Fit the Freeze Bowl in place over the locating pins. Press down on the back of the Freeze
Bowl until the bowl pin snaps into the spring latch.
NOTE:
The Freeze Bowl is designed to fit most bowl-lift Stand Mixers. If the bowl pin at the
back of the Bowl is too long to snap into the spring latch, remove and rotate the Bowl so the
blank side faces the spring latch. Repeat step 3.
4.
Place the Dasher inside the Freeze Bowl.