4
5
OPERATING INSTRUCTIONS
MAINTENANCE
Install the Blade
Lubricating the Blade
Remove the Blade
Cleaning the Main Body and Accessories
Comb Attachments
Cord Operation
A
B
1. The cutting length is marked on the comb
attachments.
2. Select a suitable size and slide the blade into the
comb attachment. Hold both sides of the comb and
push until the comb is in position.
(Notes: The Comb should be placed firmly to ensure
safe operation.)
Align the blade (B) with
the trimmer slot (A).
Push the blade into the
slot until it snaps in
position.
2. Brush off the collected residual hair from between the teeth and the blade housing.
3. Move the oscillating bracket with your thumb to separate stored hair from the
blades. Brush off the hair between the blades. Make sure that hair is not trapped
between the blades.
You may adjust the cutting length from 3 - 6mm by attaching the comb attachment.
This trimmer can be operated by plugging it into the power source when the battery
is not fully charged.
1. Switch off.
2. Connect the adapter to the wall socket.
3. Connect the DC plug to the clipper.
4. Check if the charging indicator is lit.
5. Switch “On” to operate.
1. Before or after use, drop a small amount of
oil on the red-point places shown in the left
picture.
2. Drop oil and spread evenly. Slightly move the
oscillating part to spread the oil between the
blades.
1. Switch off and unplug the trimmer before cleaning
.
2. Wipe with a soft damp cloth.
3. Allow it to completely air dry before use.
Please hold with the other hand to
avoid the blade falling off.
Press the moving part of the blade with
the thumb and then remove the blade.
Removing and Cleaning the Blade
1. Remove the blade set from the blade housing by pressing the top blade with your
thumb.
MAINTENANCE
Always switch off before removing, replacing and cleaning the blade.
Set blade adjuster to 2.0mm to reassemble blade; otherwise the adjuster does not work.
Feed tool
Post
Moving blade
Fixed blade
Blade Adjustment
Push up blade length
adjustor until it can not
move before installing the
blade.
1. The blade length adjuster is on the clipper.
2. Select the desired length of the blade by moving
the adjustment slide.
Select a blade with a suitable size before operation.
